Walia, M.K. and Hefner, M. 2019, Know the Status of Your Soils Before You Plant., University of Nevada, Reno, Extension, FS-19-17

Introduction

The first important thing to know about soil is that “soil is not dirt.” Dirt is soil out of place, just like a plant out of place is a weed. Soil is a naturally occurring mixture of minerals (sand, silt, clay, gravel, stones) and organic matter. The composition of soil varies from one location to another. However, an ideal soil has, on average, a composition by volume of 45 percent minerals (sand, silt and clay), 25 percent water, 25 percent air and 5 percent organic matter. 

Before planting any crop, it is important to know the properties and nutrient content of the soil through soil testing. Soil testing is a reliable tool for learning about key characteristics of the soil and its fertility levels. It is an inexpensive way to help growers make effective nutrient management decisions, thus maximizing crop productivity and net profits. Soil testing can also help improve the environment by reducing surface and groundwater pollution from overfertilization.  

Importance of soil testing 

Getting soil tested through a soil testing laboratory can help growers to make informed decisions on: 

Nutrient status and application rate: 

The amount of nutrients in soil varies from one geographic location to another, among cropping systems, and depending on soil management practices. Even though soils may have a large amount of nutrients, not all the nutrients are in forms that can be taken up by plants. Soil test results will provide information to the grower about the type of soil and basic soil properties, such as pH, electrical conductivity, etc. It will also determine the amount of available nutrients in the soil. Getting soils tested for nutrient status is the only accurate way to determine the amount of fertilizer needed to grow a crop. University of Nevada, Reno Extension recommends that fertilizer rates should always be based upon soil test results and crop needs. This will optimize plant growth and yield. This approach can also minimize environmental impacts and maximize net profits. 

A soil test can also help the grower to know about soil texture (Figure 1). Soil texture is the relative proportions of sand, silt and clay in the soil. Knowing the texture of soil can help a grower to make better decisions about timing of fertilizer application  (split or one-time application) and irrigation needs. For instance, it is always recommended to do more frequent and smaller amounts of fertilizer (nitrogen and potash) applications on lighter-textured or sandy soils to avoid leaching losses, as compared to applying fertilizer to heavy or clay soils. Also, crops growing in sandy soils need more frequent irrigation than those growing in clay soils. 

Crop selection:

A soil analysis report can help the grower to select a crop based upon soil properties, especially soil pH. The pH of a soil is the most important factor affecting crop production, as it influences the availability of nutrients. For instance, when soil becomes too acidic, an important nutrient, phosphorus, becomes unavailable to plants, while another nutrient, aluminum, becomes more available and can cause toxicity. In addition, some crops can grow in a wide range of soil pH levels, while others can grow well only in a narrow range of soil pH levels. For example, blueberries prefer a pH range of 4.3 - 5.0. However, soybeans grow well in a pH range of 6.5 - 7.5. So, it is important to research whether the crop can perform in a particular soil’s pH level.

Diagnosing plant problems:

A soil test is an important tool for diagnosing plant problems, especially nutrient deficiencies or toxicities. Nutrient deficiencies occur when an essential nutrient is available in amounts less than needed by a growing plant. Nutrient toxicity occurs when a nutrient is available in excess of plant needs, and decreases growth and crop quality. Getting the soil tested is one of the basic tools for diagnosing nutrient imbalances.

Time and frequency of soil testing 

Soil samples can be collected at any time of the year, but it is recommended to sample around the same month of the year to reduce seasonal variations in soil test records. In general, the most important time to test soil is after harvest and before planting of a subsequent crop. Generally, soil should be sampled every two to three years for most crops. However, for high-value cash crops, soil should be sampled and tested before each crop is planted. It is also advised to get soil tested for phosphorus and nitrogen contents prior to manure application.  

In addition, it is recommended that sandy soils be sampled and tested every two to three years and clay soils be tested every three to four years. Soil should also be re-tested every year if nutrient levels are too high or low in previous tests to determine the changes in nutrient levels. If there are problems that occur during the growing season, collecting and analyzing the soil is recommended. 

Soil sampling tools 

Tools needed for soil sampling are: 

  1. Soil sampler (stainless steel probe or shovel)
  2. Clean plastic buckets or plastic trays
  3. Sampling bags
  4. Label or markers

Soil sample collection 

Soil samples should be collected by dividing the field into similar units or blocks based upon differences in the soil. These differences could be in color, soil types, slope, drainage, degree of erosion, prior management, different crop or manure history, etc. Several random samples should be collected from each area of each unit or block (two or three subsamples per acre) in a zigzag pattern (Figure 4). Sample to the same depth to ensure uniformity. For uniform fields, a simple random pattern across the field should be used to collect at least 15 to 20 soil cores to equal depths. 

Soil sampling soon after fertilizer or manure applications should be avoided. In addition, soil sampling in or near unusual areas, such as dead furrows, areas near windbreaks or fence lines, feedlots, fertilizer bands in fields, roads, manure piles, low areas, salty spots, and old building sites, should be avoided. 

Basic steps to follow for collection of representative soil samples are: 

  1. For normal tilled crops, first remove and discard the surface litter or dead plant material.
  2. Then, dig down to a plough depth of 15 cm (6 inches) for shallow-rooted crops and 30 cm (12 inches) for deep-rooted crops (Figure 5). Most samples are taken from the surface to the tillage depth (6 inches) for field crops. This sampling depth is important as this zone has most of the root activity and also fertilizer applications are restricted to this tillage depth. However, in light-texture soils, where excessive leaching of nutrients occurs, separate deeper samples, down to 15-60 cm (6-24 inches), should be collected and analyzed to determine available nitrogen and sulfur in some cases, since nitrate-nitrogen and sulfate-sulfur are mobile nutrients in the soil and will move below 15 cm (6 inches) soil layer via leaching.
  3. If an auger is not available, collect samples by making a “V”-shaped cut to the desired depth in the sampling spot using a shovel (Figure 3). Remove and collect thick slices of soil from top to bottom of the exposed “V”-shaped cut. Never use brass or galvanized tools or containers for soil sampling, as they will contaminate the sample and will lead to misleading results. Also, avoid soil sampling during wet conditions. 
  4. All collected samples should be placed together in a clean plastic bucket or plastic tray. Break up any lumps or clods before mixing samples.
  5. Mix all the collected samples together thoroughly to make a composite sample. Any material other than soil, such as roots, pebbles, stones, etc., should be removed.
  6. From the composite sample, a mixed sample of about 1 pint (2 cups) should be placed in a clean soil sampling bag provided by the laboratory or in a plastic zipper bag. Discard any leftover soil from the sample. Label the bag with the required information, such as name, location, field area, previous crop grown, sample collection date, depth, and subsequent crop to be planted, along with a list of tests requested. The information provided and soil analysis results will help to generate the nutrient recommendations for the upcoming crop.
  7. Select a laboratory to be used for soil sample analysis. Follow the instructions carefully and mail the sample, along with the completed information sheet and payment. It is always best to take a photo of the labeled sample bag before mailing to the laboratory, for future reference. 

It is important to note that some laboratories accept the soil samples without air-drying. Other laboratories require the sample to be air-dried under shade on parchment paper at room temperature before packaging for shipment to the laboratory for analysis.  Do not oven-dry the soil samples.  
It is advisable to contact the selected laboratory before taking a sample, to confirm the type of test needed is still being offered and to receive special instructions to follow regarding collection, packaging, mailing, and information to be submitted with the sample.  

There is a list of laboratories provided in Table 1 at the end of this fact sheet. The laboratories listed belong to the North American Proficiency Testing program (a program of the Soil Science Society of America). 

Soil sample analysis 

A standard soil test will provide information on soil pH, cation exchange capacity, lime requirement index and contents of some nutrients (phosphorus, potassium, calcium and magnesium). Soil testing laboratories can also provide information on soluble salts, nitrate and ammonia nitrogen, total nitrogen and carbon, soil texture, organic matter, and other major and minor nutrients for additional fees. Laboratories may provide, for a fee, recommendations based upon the soil analysis and crop needs. Laboratory results and recommendations usually will be sent back in two weeks. However, any incomplete forms or inaccurate payments will delay the processing of samples and receipt of results.  

Results from the laboratory will help producers to make the most of fertilizer, manure and amendment (lime, gypsum, sulphur, etc.) applications for crop production. This will also help producers to recognize changes in soil fertility over time and adjust application rates based upon crop needs, thus avoiding over-application of nutrients, saving the associated cost, increasing fertilizer use efficiency, and reducing the environment degradation at the same time. 

Authors of this scholarly work are no longer available.

Please contact Extension's Communication Team for assistance.

 

Also of Interest:

 
tomatoes on the vine
Combatting Salinity: Evaluation of Tomato Rootstocks Under Mild and Severe Salt Stress
This Extension publication reports the results of University of Nevada, Reno Experiment Station research that tested six different commercial tomato rootstocks and one commercial tomato cultivar for salt tolerance under low, moderate and severe salinity levels.
Bonarota, M.S., Barrios-Masias, F.H., & Singletary, L. 2021, Extension, University of Nevada, Reno FS-21-08
Christina T. Igono
First-generation Ph.D. student Christina T. Igono presents, wins award at international conference of soil scientists
"It is imperative professionals in my field develop sustainable agricultural practices, mitigate greenhouse gas emissions and reduce natural disasters or we might not survive."
Andrews, A. 2020, Nevada Today
Planning for Plant Growth using the Grazing Response Index
Informational publication on how to plan for plant growth in forage and various crops using the Grazing Response Index as a guideline.
Swanson, S., Voth, D., Cervantes, J. 2019, Extension, University of Nevada, Reno, IP-19-03
Soil and Climate Considerations of Alternative Crops
To determine which alternative crop or crops are best suited to a particular producer, it is necessary to determine the soil and climatic conditions under which the crop will be grown. This will influence the amount of probable yield, which impacts the possible economic returns.
Bishop, C., and Emm, S. 2013, Extension | University of Nevada, Reno, FS-13-27
Nevada Youth Range Camp (History)
Nevada Youth Range Camp focuses on relationships between people and rangeland. Campers learn that land managers need information about plants, wildlife, water and soil to make good decisions about rangeland management and use. The camp challenges youth to explore resource problem...
Foster, S., McCuin, G., and Schultz, B. 2009, Extension | University of Nevada, Reno, IP-09-05